Gear Speed Table Calculator

When to use it

• Compare how a change in engine speed affects speed in selected gear before committing to parts, setup, or strategy changes.
• Check a workshop, dyno, simulator, or trackside spreadsheet result using a transparent formula: RPM × circumference ÷ selected overall ratio.
• Use the result to compare gearing choices before changing ratios, tyres, sprockets, clutches, or shafts. Real acceleration still depends on the power curve, traction, aero drag, shift time, and component strength.

How to use it

1. Enter engine speed in rpm; the default value shown is 7,000 rpm.
2. Enter tyre diameter in mm; the default value shown is 650 mm.
3. Enter selected gear ratio as a plain number; the default value shown is 1.2.
4. Enter final drive as a plain number; the default value shown is 4.1.

How to read the result

Speed in selected gear is shown in km/h. Use the number as a calculated reference point, then compare it with measured data from the car, the part supplier, or the race environment. A mathematically clean answer can still be unsuitable if the inputs are estimated, rounded, measured under different conditions, or outside the normal range for the vehicle.

Assumptions and checks

• The calculator applies the displayed formula directly and assumes the entered engine speed, tyre diameter, selected gear ratio, and final drive are valid for the vehicle and conditions being considered.
• Changing engine speed and tyre diameter together can move the answer in ways that are easy to miss, so make related setup changes deliberately.
• Use loaded tyre diameter or measured rollout when gearing accuracy matters.
• Compare the result with RPM limits, shaft limits, and the usable power band.
• Allow for tyre growth, slip, clutch capacity, and drivetrain losses where they apply.